Worksheet – US 24357 (v2) Receive instructions and communicate information in relation to BCATS Projects

Student name:

Situation – You have been given the following specifications and asked to construct this item:

What is this item?

Use the given information to construct a cutting list and work out what additional information you would need in order to commence the task.

The table top is to be constructed out of solid rimu – ex 160 x 25. Include this in your cutting list calculations. All joints are to be dowelled.

Complete the cutting list required to show the net sizes of all the timber needed to construct the table (i.e. allow no waste).

Part	Number of	Length	Width	Thickness	Total length
Top
Side rails
End rails
Legs

List at least THREE questions, relevant to the success of the job, which you would need to ask before starting construction:

(i)

(ii)

(iii)

Situation 2 – This project is to be fitted into an existing wall cavity. Below are the job specifications:

The shelf is to fit into an existing hole 1000 wide x 700 high x 300 deep.

Material to be used is 18mm radiata pine.

All joints are to be housed 6mm into the sides.

All measurements in mm.

200 1000 232 700 300

What will this project be used for?

Is all the information you need to complete the project available?

Prepare a materials cutting list:

Part	No. of	Length	Width	Thickness	Total length	Comments
Top
Bottom
Sides
Shelves

If the radiata pine is not available in the sizes you have ordered, what questions will you need to ask the supplier to ensure that you can start the project as soon as possible?

Situation 3 – You have been given the following project details. Look at the details and answer the following questions.

What are some of the uses for this project?

Prepare a cutting list for this project.

Part	No. of	Length	Width	Thickness	Total length	Comments
Top
Bottom
Sides
Shelves

What other information will you need to prepare a materials order form?